Hi,
Before a while I brought away bulky waste and there I spotted a coal bowl in the scrap container.
I asked if I could have the hut and took it with me.
The coal bowles reminded me of how I had dragged the things from the basement to the 2 floor earlier.

The other day Frithjof was here to visit me and he supported me in drawing a handling of it, thank you again for it.

Based on this data, I built myself a bending pipe.

I milled the process to sample from a remnant 0.2 mm messium sheet and was able to build a first pattern.

With the help of teaching and now made of 0.1 mm of new silver sheet, small-batch production could begin.
On the apprenticeship, the sheet is bent and then pinned with a little lot.
The actually soldered is then done.
In the next step, the handle is soldered to the spill with two 0.5 mm wire pins.
Then the floor is also soldered and below a wire bent on the bending tube for the lower end. This wire also serves as a stand around the bounded edge below.
The handle is also a milling part again and is also used with two 0.5 mm wire separators, which are bent over inside and so this remains movable.

For comparison soldered soldered bending part and finished coal shards.

Here the coal sheds from below, so that the Wulst from the 0.5 mm can also be seen correctly.

Size comparison a finished coal bowl in my hand.

After that everything still clean and blackp and already the small series is ready.

So now my little Helmut can fetch coal in the mine.

Exactly, because there is even real coal in the model.