Print Page - Parts Bins in 1/87 and 1/48

Title: Parts Bins in 1/87 and 1/48
Post by: Rail and Tie on February 10, 2026, 08:03:13 PM

While these were straight forward to design and went together well in HO and O scale, filling the bins with odds and ends was a bit time consuming. I think the results were worth it though. Anyways, thought I would share.

A short tutorial as well
https://youtu.be/LejM9NJNHCE?si=xa6SKkYh_6OGP8UN

Title: Re: Parts Bins in 1/87 and 1/48
Post by: lab-dad on February 11, 2026, 05:33:35 PM

Nice!
Filling it is the hardest pert.
MJinTN
Think this would work 3 times the size of O scale in 1/16" plywood?
I made mine from scratch.
Could use a couple more

Title: Re: Parts Bins in 1/87 and 1/48
Post by: Rail and Tie on February 13, 2026, 07:47:40 PM

Quote from: lab-dad on February 11, 2026, 05:33:35 PMNice!
Filling it is the hardest pert.
MJinTN
Think this would work 3 times the size of O scale in 1/16" plywood?
I made mine from scratch.
Could use a couple more

Might have to give that a try if I get a chance.

Westlake Publishing Forums

General Category => Modellers At Work => Topic started by: Rail and Tie on February 10, 2026, 08:03:13 PM