The handling of micro parts.

[Design-HSB]

Once I was in my thread mine locomotive, yes after asking especially after handling the micro parts, here are some explanations.
It was triggered by the following picture.

From Left to Right.
7 spikes thumbscrew outlets back, wing nut, socket and supervisory control.
In the production I must always think in advance as I can keep the micro Teole until the end.
Therefore, I milled the parts usually made from a brass plate with the appropriate thickness and allow to stand at the base 0.2 mm.
Finally I then milled the part then finished and turn the suction for the chips out there.


For lifting the micro parts to such a pair of tweezers with cross-hatch cross cut has proven.

During further processing, it also depends on the ergonomics.
Optimum sitting and good lighting help much.

In addition I have a motorized height adjustable desk with undercounter lighting.

Thanks to the light I find that almost always, again all fallen micro parts.

[Chuck Doan]

Thanks for the info!

[Gordon Ferguson]

I have a motorized höhenverstellbareren

I have no idea what one of these is ...... But it sounds great and I want one !

Fascinating stuff as always

[Design-HSB]

Sorry Gordon, height adjustable desk.


I can even stand in the work on the table.

[Ray Dunakin]

Good suggestions, especially the tweezer idea.